Packed THREE to a box.
This battery is specifically geared towards the BabyTooth 1S 3” platform. It performs very well and will provide slightly more flight time than the 450mah 80C pack if you do not push it in flight and only cruise slowly. This is a good pack but the 450mah 80C pack is currently what's recommended.
About voltage on 1S cells:
Traditionally, we don’t want to run any LiPo below 3.3v/cell under actual use (under load) in flight. The actual issue is overdrawing amps from the cell which can cause overheating and sharp drops in voltage. 1S is a little different because it’s relatively difficult to overdraw the current from such a small cell that has such low voltage to begin with. This is why Whoop flyers generally land at 2.9v under load. If you slowly discharge a lipo, it does not damage it to drop it down to 3v/cell and that’s basically what we’re doing with these very low voltage and low overall wattage crafts. Because this 3” 1S platform is more capable than the majority of other 1S quads, we would recommend landing when you see 3.0v in your OSD.
Specifications:
- 1S 600mah
- STANDARD VOLTAGE 3.0-4.2v
- Not recommended to run below 3.0v in flight
- 50C/100C
- XT30 connector on a ~17mm lead
- 15.5g with XT30 attached
- 60x18x8mm
1S 3” Drivetrain:
- FPVCycle 1202.5 11,500kv 2mm press fit props
- Gemfan 3016x3 2mm press fit
- BabyTooth frame in 2mm
- Any of the 1S AIO boards we offer
TP3 recommended FPV Setup:
- Bee Brain V2 camera mount
- OV231 FPV camera or RunCam Nano 3
- D400 Vtx
- or an AIO 25mw Whoop cam