This is a bolt on GoPro Hero 5/6/7 Mount for the FPVCycle CineGlide, CineSplore & Fouride. Printed out of TPU and available in a variety of colors.
These mounts are all designed to be used with our ND filter. The Hero 5/6/7 mount requires the additional bumper to hold the ND filter.
We recommend 10deg mounts for the CineSplore and 20deg mounts for everything else. If you’ll be flying a little faster, go with the 30deg mount.
Bring a pot of water to a boil and then drop the TPU mount into the water for exactly 1 minute. Remove the mount, let it cool for a few seconds so you can touch it and then stuff the camera into it and let it finish cooling. This makes the case feel like butter when you use it from then on. Really super nice feeling and still fully functional and effective.
When using an ND filter, you will not see the very corners of the mount in the camera view. Without the ND filter in place, the very very edge of the corners view will have a tiny bit of the guard visible. Even a 1-2% crop takes care of this if it's a problem or ANY degree of stabilization.
Very nice clean mount brain3d are best
They mounts came quickly and fit perfectly. I would say the fit and finish are flawless. I noticed that the brand was Brain3D. Always high quality products from there. Thank you FPV Cycle for the quick service.
Mount is printed very well and fits perfectly
It fits perfectly. The GoPro is snug so I don't have to worry about it flying out. No complaints.