New look, minor tweak to internal stator design, improved low end prop handling, new prop mount, less weight, screw retained bell. These motors are compatible with the previous 2203/4. If you mix them on the same craft with similar kv, you won't be able to tell a difference in flight performance.
We haven't used a better performing 3" cinewhoop motor than this one...
This motor is specifically designed for the following uses:
3” ducted whoop
5” light blade and low general AUW for 5”
CineSplore w/ Gemfan 75mm CineWhoop prop
PowerPick 4” with Gemfan 4023 prop
PowerPick 5” with Gemfan 5125 prop
Fouride 4” with Gemfan 4023 prop
Fouride 5” with Gemfan 5125 prop
Red T-mount props are fantastic with Gemfan 4024
3000kv version is suitable for CineWhoop/CineSplore on 6S if desired
Recommended battery options:
3S 1000-1500mah on 3450kv with CineWhoop 3”or 4” open prop
4S 1100-1300mah on 3450kv with CineWhoop 3” or 4” open prop
3S 1100-1300mah on 3450kv with 4" or 5" open prop
4S 900-1300mah on 3450kv with 4" open prop
4S 1100-1300mah on 2350kv with 5" open prop
4S 1100-1300mah on 3450kv with CineWhoop 3”
5S 1100-1300mah on 2350kv with CineWhoop 3” or 4” open prop
6S 850-1000mah on 2350kv with CineWhoop 3”
You’re welcome to run full 4S with no throttle cut on 3450kv and 5” but be warned that it will be extremely overpowered on a very light platform and a challenge to deal with the electronic noise due to the high power. If your filters and overall electronic management is not done right, the motors have some risk of burning. Even though these motors have super high temperature enamel coating on the winds, we are not responsible for burnt motors due to misuse.
- 23mm stator diameter, greater than 3mm stator height
- 12x12mm M2 mounting pattern (not flush mount)
- ~17g with ~80mm length wires
- ~20g with prop adapter, nut and 240mm 24awg wire length
- 0.15mm Kawasaki High performance laminations
- N52SH ARC magnets
- 3mm grade 5 titanium internal shaft
- M3 grade 5 titanium prop shaft with M5 adapter
- 3x8x4mm 683zz Japan ISC Custom bearings
- 7075-T6 aluminum casing
- 260℃ enamel coated single wrap oxygen-free copper windings
These motors paired with the Gemfan D76 props are very current hungry! I now have to use a 1300mah or 1500mah battery to get 4min flight.
Out of the other 2 sizes and kv’s of cinewhoop motors that I’ve tried these out perform them by far in terms of power, efficiency and flight performance.
Very nice motor on toothfairy2.
I use 2350kv on 4s 850 mAh give me plenty time 6minutes fly easy ( cruise and light free style)
I like them very much !!!!
Dont have a lot of whoop experience but these motors are performing nicely. Managed to burn the winds on one and it flew for a while before failing. Probably a tuning issue. These whoops are finicky.