This is a bolt on GoPro Hero 9 and 10 Mount for the FPVCycle CineGlide, CineSplore & Fouride. Printed out of TPU and available in a variety of colors.
These mounts are all designed to be used with our ND filter. The Hero 5/6/7 mount requires the additional bumper to hold the ND filter.
We recommend 10deg mounts for the CineSplore and 20deg mounts for everything else. If you’ll be flying a little faster, go with the 30deg mount.
Bring a pot of water to a boil and then drop the TPU mount into the water for exactly 1 minute. Remove the mount, let it cool for a few seconds so you can touch it and then stuff the camera into it and let it finish cooling. This makes the case feel like butter when you use it from then on. Really super nice feeling and still fully functional and effective.
When using an ND filter, you will not see the very corners of the mount in the camera view. Without the ND filter in place, the very very edge of the corners view will have a tiny bit of the guard visible. Even a 1-2% crop takes care of this if it's a problem or ANY degree of stabilization.
I built an Incisor and since it can run a 20-degree tilt with no props in view, this is the mount for it. My only complaint is that I can't just print one myself, but at least it fits an ND filter which is a must.
First product from this store that i am not impressed with. Really hard to get the cam in and out. Doesnt hold the nd filter in securely nor is it a good fit. Can see the mount in the gopro footage when using superview with no stab. Quality print just not a good design in my opinion.